Gibson GNGJ90JGVC Manuel d'utilisateur télécharger pdf (Page 25)

2. Carefully remove from the burner the

thermocouple A. Next remove the spark

plug B.

A

B

3. Unscrew the screw and slowly pull out the

burner.

1

2

4. Release the burner injector with a 7 mm

socket spanner and replace it with a right

one.

Assemble the burner in a revers sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the new

gas type.

Adjusting the minimum gas level on the

oven burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the oven functions.

If there is no access to the bypass screw

dismount the control panel before

adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

A

A

Changing from natural gas to liquid

gas

1. Fully tighten the bypass screw.

2. Put the knob back.

3. Connect the appliance to the electricity.

Changing from liquid gas to natural

gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the oven functions back.

3. Connect the appliance to the electricity.

WARNING!

Put the mains plug into the

mains socket only if all parts

are back into their initial

position. There is a risk of

injury.

4. Light the burner.

Refer to "Oven - Daily use" chapter.

5. Turn the knob for the oven functions on

the minimum position.

6. Remove the knob for the oven functions

again.

7. Screw on slowly the bypass screw till the

flame becomes minimum and stable.

8. Put the knob for the oven functions back.

9. Set the maximum gas flow position on the

knob for the oven functions and let the

oven heat for at least 10 minutes.

25

1 2 ... 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire